First, earnestly implement the relevant provisions of the "General Operating Rules for Forging Equipment".
Second, earnestly implement the following supplementary provisions:
(1) Seriously before work:
1. Before the test run, the machine should be manually operated by a manual drive to confirm the normal operation before starting the equipment.
2, equipment with hydraulic equipment, check the oil storage tank should be sufficient. After starting the oil pump, check the valve and pipeline for leaks. The pressure should meet the requirements. Open the bleed valve to remove air from the system.
(2) Seriously doing work:
1. It is not allowed to cut the laminated sheets, and it is not allowed to trim the edges of the raw sheets, and it is not allowed to cut the narrow sheets and short materials.
2. The gap between the blades should be adjusted according to the thickness of the sheet, but it should not be greater than 1/30 of the board. The blade should be fastened firmly, and the upper and lower blades should be parallel. After the adjustment, apply the manual test to avoid accidents.
3. The cutting edge of the blade should be sharp. If the edge of the blade becomes dull or cracked, it should be replaced in time.
4. When cutting, the pressing device should firmly press the sheet material, and it is not allowed to cut under the condition that the pressure is not tight.
5, with hydraulic equipment, in addition to throttling and other hydraulic valves are not allowed to adjust privately.
6. For the thickness of the shearing sheet of the hydraulic pendulum shearing machine, it should be determined according to the “curve diagram of the ultimate strength of the sheet and the thickness of the sheetâ€.
(3) The upper blade should be placed in the lowest position after work.
Antiskid Plate
antiskid plate is a production which not easy rust,acid resistance and corrosion resistance, so it is widely used in light industry,heavy industry,daily necessities and the decoration industry. My company long-term supply stainless steel products, including stainless steel seamless pipes,stainless steel bar and Stainless Steel Sheet .
1. Material:201,202,301,302,303,304,304L,309,310,316,321,410,410S,420,420J1,430,304F,316L,
316F,316Ti,310s,314,314l,317,317l,302HQ.
400series:416,410,420,420J2,430,430F,431.
2. Standard: ASTM, AISI,JIS, DIN
3. TK:0.4-10mm
4. Width: 1000mm-6000mm
5. Surface: 2B, BA, HL, NO.1,etc.
6. USE:construction.machinebuilding,container manufacturing,shipbuilding,bridges and so on.
Common plate use:a variety of widely used to make containers,furnace shell,furnace plates,bridge still,the ship building plate and so on.
Antiskid Plate
Antiskid Plate,Metal Antiskid Plate,Steel Antiskid Plate,Metal Mesh Antiskid Plate
CSTAR WIRE MESH ENTERPRISES CO., LTD. ,