Most families in the renovation of the bathroom, the habitual to remove the original bathroom wall tiles, and then re-lay new tiles; so you need to do a waterproof project in the toilet wall. If there is a quality problem in the waterproofing project, it will cause serious economic losses to the family and the neighbors. Here's come with me to understand the next few things to note the next bathroom renovation !
Renovation of the bathroom five major considerations
The second consideration of bathroom decoration: ground treatment
If you need to change the floor tiles of the bathroom, you must use the cement mortar to level the floor after the original floor tiles are cut away, and then do the waterproof treatment. This can effectively prevent leakage of waterproof coating due to uneven thickness. The seams should be brushed in place; the joints between the bathroom wall and the ground, the seam between the upper and lower water pipes and the ground are the most prone to problems. Everyone in the construction must urge the workers to deal with these corners, so waterproof paint must also be in place.
Second, anti-slip tiles are used on the bathroom floor. General matt surface or shallow convex floor tiles can effectively play a non-slip effect. The floor of the bathroom should be 10~20mm below the floor of other rooms. When laying tiles, consider the location and size of the floor drain. Usually, the laying of bricks retains a slope of 1% water leakage, and the floor drain is the lowest, which is conducive to drainage. Tile seams should be the same thickness and alignment with the wall tiles.
Second Renovation Considerations for Bathrooms: Wall Treatment
In the treatment of bathroom waterproofing, a waterproof coating of about 30 cm is also required on the wall to prevent water accumulation from permeating the wall. However, if the bathroom wall is a non-load-bearing light wall, the entire wall should be painted with waterproof paint. If you use a two-panel shower screen in your home, the two-in-one wall should be painted. If you are using a bathtub, the height of the waterproof coating on the wall adjacent to the bathtub will be higher than the top edge of the bathtub.
Wall tiles should be full. Tiles can effectively resist the erosion of moisture, protect the waterproof layer of the wall, and at the same time maintain a neat and beautiful appearance for a long time. Households using ceilings should pay attention: The part covered by the ceiling should also be covered with tiles in order to protect the entire wall.
Renovation considerations for bathroom second: Dry and wet separation
At present, the most popular foreign idea is the “dry and wet partitionâ€. In fact, it refers to the separation of the toilet bowl, the basin area and the shower room. Professionals said: "Dry and wet areas can be divided by using different materials and colors of the tiles, so that the two will not interfere with each other, and at the same time can avoid the kind of splashes in the past, after bathing East wipe the West wipe awkward."
Bathroom secondary decoration matters needing attention four: waterproof experiment must do
When the toilet construction is completed, you can block all the inside drains, and then build a “can†about 25 cm high at the entrance of the bathroom. Finally, remember to pour 20 cm of water into the bathroom. After 24 hours, look at the floors and walls around you and see if there is any leakage. In fact, this is the waterproof test in people's mouth, and it is also a key step to ensure the waterproof quality of the bathroom, so it is an indispensable process.
Five Remarks on Secondary Renovation of Bathrooms: Maintaining Unobstructed Water
The owners need to pay attention to all the sewers in the bathroom, such as sanitary ware, floor drains and other sewer pipes. Because only in this way can we really avoid the "flooding seven army" tragedy.
Editor's summary: The above is the introduction of the five major matters that need attention in the secondary renovation of the bathroom , hoping to help you in preparation for the renovation. For more information, please continue to follow our website. Follow-up will show more exciting content.
Bathroom secondary decoration
Polyester Geogrid ( FG) Stitched With Nonwoven Geotextile Impregnated by Bitumen: Ultimate tensile Strengths from 25kN/m to 1200kN/m . Biaxial, flexible high modulus Polyester Geogrid stitched with nonwoven geotextile together impregnated with bitumen using the knitting process.
1. It reinforce old asphalt concrete road surface and asphalt layer, and prevents damage ;
2. It is used for rebuilding cement concrete road surface into composite road surface and restraining reflection caused by block contraction .
3. It is used in road expansion and improvment project and crack caused by old and new combination position and uneven sedimentation ;
4. It is used in soft soil base reinforcement treatment , is favorable for soft soil water separation and concretion,restrains sedimentation effectivly,distributes stress uniformly and improve overall strength of road base;
5. It is sued for preventing contraction crack caused by new road semi-rigid base layer,and reinforces and prevents road surface crack caused by foundation crack reflection.
Asphalt Reinforcement Geogrid, Asphalt Reinforcement Composite, Pet Geogrid
Feicheng Lianyi Engineering Plastics Co., Ltd , https://www.lianyigeosynthetics.com