When decorating a home, you must carefully check the quality of the floor decoration and do a good job of acceptance.
1, see if the color of the floor is consistent
If the color difference is too large, it directly affects the appearance, and can be exchanged. If the color is too consistent, there is almost no color difference, then it depends on whether the pattern on the floor surface is the same.
2, see if the floor has a sound
During the acceptance, walk back and forth on the floor, the footsteps must be aggravated, especially the wall parts and the door hole parts should pay more attention to the acceptance, and find the parts with sound, you must repeat the movement, determine the specific position of the sound, and mark well. In this case, you can ask to remove the resurfacing.
3. Accept the deformation and warpage of the floor.
The method of acceptance is to use a 2 meter long ruler and lean against the floor. The flatness should not exceed 3 mm.
4, the acceptance of the baseboard
The gap between the skirting line and the door frame is ≤ 2 mm; the spacing between the baseboard seams is ≤ 1 mm; the gap between the baseboard and the floor surface should be in the range of 3 mm to 5 mm; the height difference of the baseboard buckle should be ≤ 1 mm.
5, the acceptance of the door buckle
The door buckle strip should be installed directly under the door. It is better to leave the door inside and outside after closing the door. The gap between the buckle and the bottom of the door is between 3 mm and 7 mm, and the door can be opened and closed freely. The installation of the buckle should be firm and stable. You can kick the middle part of the buckle with your foot and check whether the two sides of the buckle are lifted or loose, and there is no abnormal sound.
6, the final acceptance of the surface of the floor is blind, gaps, scratches
It is common because the ground keel is untreated and there are mites inside.
Gas Vaporizer,LNG Vaporizer,Ambient Vaporizer
Cylinder,TABLE TOP GAS STOVE Co., Ltd. , http://www.nscylinder.com